Production of loops of port. For a start I cut out a strip from brass. By means of a tools I curved loops.


Having sealed a bar in one of half of loops I have drilled openings and blackened all. Including also carnations.


Behind that I sawed up to the end a cover of port and finished it the necessary condition.


Well and at the end I fixed by loop carnations on a cover of port.

I began to make port. It will consist of two parts and an opening under a carronada. At first I divided an external packet of laths of port into 2 parts and made a marking.

Behind that I made internal “boards” of port. I cut them so that they were aflush with an internal surface of a board.


At first I have pasted on the ends external laths, having made in advance I sawed around what then it would be easy to separate a cover on two parts.

After that I have pasted the others, previously having removed superfluous.


Когда клей высох я с помощью сверла удалил внутреннюю часть крышки порта.


And using pine forest the machine I turned all opening. After that I ground and I polished an external black surface of a cover of port.

I finish a carronade. On a photo all is visible.



Well and a сarronade assembled as it shall look.




After full assembly I have covered everything with tung oil.