Part #7

And so correctly to make an opening in a cover of port the carronade should collect on a gun carriage.
Carronade consists of three parts which I successfully soldered together by means of regular solder and acid.
20160907_092047
Some details to her.
20160907_121701
By the same method I have soldered the aiming screw.
20160908_151057
After that I blacked all main details of a carronade and auxiliary details of set.
20160908_152333
And here I haven’t kept, I have made a photo of temporarily collected carronade. 🙂
20160908_163833

Part #6

I do a reverse side of a board. I have pasted rigidity there where they will be necessary.
20160902_102201
20160902_150502
20160902_150509
I made procurements of a black hornbeam for cap rail and covers of port.
20160902_150543
20160902_150559
20160902_152355
Further I have made rigidity for fastening of the gun from outer side of a board. Also I have made imitation of fastening of boards from outer side of a board.
20160905_143020
20160905_155338

Part #5

Well, we will continue?
I didn’t begin to take a board from a kit. It is made of a whole tree with kerfs for simulation of boards. Generally totally ludicrous. I decided to do all over again. I sawed rails 10х1,5, I cut the stands imitating frames. I pasted stands to the base and I strengthened wooden tongues.

30081
30082
30083
30084
30085
I decided to do port with quarters under a cover. For this purpose I used covering laths, without finishing gluing them to edge of a box of port.
30086
30087
30088

See you again.